|
|
Largest Selection of Vacuum Motors and Parts on the Internet!!!
These OD motors are
not flat bottomed - see Diagram
These NEW 8.4" Motors DO NOT require a leakage hole and the are thermally protected!
What to know about 8.4" vacuum motors
8.4" Video https://www.youtube.com/watch?v=hCE3-c1sd9c
You must use some
kind of gasket 3/8"
You must
have at least 3/8"(Drilled Hole in
the bottom of your table or plumbing) for the OD motors. This must be filtered
air - possibly using a filter like a ShopVac uses to cover all the holes that
you have drilled.
We had a customer who
was cutting full sheets and his muffler's 90 degree coupling was getting soft and not staying connected. The customer was using the OD motors. The motors only lasted 6 weeks - not good! We both learned together
5.7" - Self-stick - 1 7/8" hole by 3/8 thick for Lighthouse Brand or Ametek Lamb Motor - Gasket $5.99 when purchasing a new vacuum motor This is the correct gasket for all motors on this page!
http://www.talkshopbot.com/forum/showthread.php?t=11813 These guys are very creative!!! ALL have dual ball bearings and a metal horn! |
Copyright Lighthouse Enterprises 1998-2023
|